MyIoT RPICM3

MyIoT RPICM3 Datasheet

MyIoT-RPICM3 is a device based on the “Compute Module 3″, able to make Rasperry Pi suitable for use in professional environments. The device is built around the “Compute Module 3″ module, the “professional” version of Raspberry Pi and is composed of a series of “bases” that allow you to expose the main peripherals available on the CM3, and not only. All inserted in a DIN bar compatible container with two modules. It has an Ethernet LAN 10/100 port compliant with the IEEE802.3 / 802.3u standard; two USB2.0 ports, an internal micro USB port for programming the eMMC memory related to the CM3 module (if available); RTC already configured and operational (battery CR1025, Li / MnO2); 8 Output ports with non-opto-isolated push-pull driver, 3-state function that can be activated on two groups of 4 lines, protection against overtemperature, maximum output current per channel 50 mA, maximum output frequency 50 kHz. + 5V interface power supply, the 0V is in common with the 0V of the module power supply and must necessarily be connected externally to the module itself. It also has a screw terminal block for DC 9 ÷ 28V power supply input (protection against polarity reversal through resettable fuse) and for RS485 half duplex interface from 1200 to 115200 baud with automatic management of transmission direction and fail-safe mechanism, “Reset ” of the system.

Housing for Raspberry Pi CM3 industrial module (Compute Module 3)
1 10/100 Ethernet LAN port compliant with IEEE802.3 / 802.3u standard
2 USB 2.0 ports
Internal micro USB port for programming the eMMC memory related to the CM3 module (if available)
RTC already configured and operational (battery CR1025, Li / MnO2)
1 Screw terminal board for DC 9 ÷ 28V power supply input (protection against polarity inversion through resettable fuse) and RS485 half duplex interface from 1200 to 115200 baud with automatic management of transmission direction and fail-safe mechanism
1 System Reset button
8 Output ports with non-opto-isolated push-pull driver, 3-state function that can be activated on two groups of 4 lines, protection against overtemperature, maximum output current per channel 50 mA, maximum output frequency 50 kHz.
+ 5V interface power supply, the 0V is in common with the 0V of the module power supply and must necessarily be connected externally to the module itself.
ATTENTION: the protection against polarity inversion on the power supply is not currently implemented (in the future versions a push-pull interface with the same basic characteristics will be available, but opto isolated and with extended power supply at 5 ÷ 30V).

 

myiot_med




ORDERING CODE

RPICM3XXXnnn
TYPE

RPICM3

ASSEMBLY

S0: without battery and Compute Module (base)

CUSTOM